User's Manual

Infinition Inc. Rev. 02
5
4.2 Configuration Menu definitions
When the Display/Parameters button is pressed, a menu appears. The following options are available:
Menu selection Description
Velocity Units
Change the units used when displaying velocity measurements, the user can
choose from the following units:
 Feet per second (fps);
 Yards per second (yps);
 Miles per hour (mph);
 Meters per second (m/s);
 Kilometers per hour (Km/h).
Distances units.
Change the units used when displaying distance measurements, the user can
choose from the following units:
 feet (ft);
 yards (yd);
 meters (m).
Weight units
Change the units used to enter the weight of the projectile, the user can
choose from the following units:
 gram (g);
 grain (gr).
Select vel. range
Select the velocity range for measurements by the LabRadar. Each velocity
range is specified to weapons type as a reference:
 Rifle (300m/s to 1050m/s);
 Handgun (75m/s to 525m/s);
 Archery (20m/s to 225m/s).
Set proj. offset
Input the distance between the gun’s muzzle and the side of the radar to
optimize the precision of the measurements.
Set distances
Specify the distances at which the velocity measurements are made. Dx1 to
Dx5.
Proj. Weight
Set the projectile’s weight of the next shot. This value is used in some
calculations (Power Factor, Kinetic Energy) and written on the file on the SD
Card for future reference.
Arm time
Change the amount of time the radar stays in transmission before it stops
transmitting automatically. This count will be reset each time a trigger is
received.
Screensaver: Select the idle time before the screen is turned OFF, this is an energy saving
feature. The device will continue to operate while the screen is turned off,
pressing a button or triggering the unit will wake up the screen.