User's Manual

Infinition Inc. Rev. 02
11
The data recorded in the internal memory only (while there was no SD card inserted) cannot be accessed by
USB.
4.3.11 Recording Projectile Velocities
Each shot is recorded in the sequence that it was fired in. The Series and Shots can be reviewed on LabRadar
or on a PC at a later time. LabRadar provides the ability to record up to 1,000 shots in 1,000 different series.
The only other limitation is the space available on the SD card.
4.3.12 Series and Shot Navigation
When the LabRadar detects a projectile the velocity is recorded in the currently selected Series. This causes
the number of shot velocities in the Series to increase by 1. This will continue until the user selects another
series number. The first shot of that series will be shot 1 and will continue counting up until another Series in
selected.
If the system is turned off, it will continue to record shots in the last series used when power is restored.
Should you choose to fire additional shots in a previous series toggle back to that Series and continue firing.
The additional shots will be recorded in the selected Series.
4.4 Display details
Battery Indicator
There is an icon on the display of the LabRadar that indicates the battery condition. If the battery voltage
becomes insufficient to operate, the system will shut down.
Bluetooth Indicator
There is an icon on the display of the LabRadar that indicates when a Bluetooth connection is active. When
there is no Bluetooth connection, the icon is not shown on screen.
Radar Signal Strength Indicator
The signal strength indicator is located on the side of the measurements results of the last shot, either in the
Armed View or the Last shot review mode. It gives an indication on the quality of the signal that is analyzed
by the device. 5 bars = Best, 1 bar = Bad signal.
Instructions
Error Message
If the LabRadar is receives a trigger event but does not detect valid projectile signal, the following message
will be displayed on-screen: “Acquisition error: could not track the projectile”. The system will not record
that shot, neither will it make any measurements.
Before trying again, check the following:
 The alignment of the radar unit.
 Confirm that a projectile went through the Labradar beam area
 Check your weapon to insure it operated properly and is safe to fire again
 In the event the unit is powered off or the battery is depleted, the shot data is stored on
the SD card and no data will be lost.
8/14structions
Extreme Spread (ES)
The Extreme Spread, is the lowest velocity subtracted from the highest velocity of the current series.