User's Manual

Switch configuration

Technical User Manual

InfiLINK XG – CLI commands

3. Switch configuration

3.1. Default settings

The access to the device is performed through any external port

IP-address of the unit: 10.10.10.1/24

By default the switch operates in isolate mode, i.e. all the ports are isolated

from each other, even if they are located in the same VLAN

All the ports operate in trunk mode with native VLAN 1 for untagged traffic

Radio interface is up and operates within the switch as a regular port

DHCP-client is enabled on the management interface MGMT

3.2. Command description

3.2.1. PORT command

Use this command for the built-in switch management.

Syntax:

#1> port [arguments]

port [-scheme=SCHEME] [-mgmt=PORT_SET] [-radio=PORT_SET]

port -d1q[=[disabled|enabled]]

port -vlan={RANGELIST} [{-priority=PRIO|-nopriority}]

port -vlan={RANGELIST} [-stp] [-nostp] [{-spriority=STPPRIO|-

nospriority}] [-sforward[=enable|disable]]

port -vlan={RANGELIST} -remove={RANGELIST}

port [PORT_SET] [-access=TAG] [-native=TAG] [-mode={access|trunk}]

port [PORT_SET] [-allow={RANGELIST}] [-disallow={RANGELIST}]

port [PORT_SET] [-limit={RATE_LIMIT}] [-nolimit] [-

qosmode={wrr|st3|st23|strict}]

RANGELIST: RANGE[,RANGE...]

RANGE: {TAG[-TAG]|all}

PRIO: {0..7} - DOT1P frame priority

RATE_LIMIT: {0..1000} - port egress rate limit in Mbit/sec

STPPRIO: {0..15} | {0,4096,8192...61440}

Port set <PORT_SET>:

enumeration of {[ge]0..[ge]1,s[fp],m,r}|*, for example 0,ge1,m

Adjacency scheme <SCHEME>:

{isolate, transparent}

Command arguments:

The switch can operate in one of the following modes: isolate or transparent.

In isolate mode, packet switching is based on the port isolation rules. External

ports are isolated from each other and traffic from each of them is redirected to the