User's Manual

INTRODUCTION
Technical User Manual
InfiLINK XG – CLI commands
1
1. INTRODUCTION
1.1. Document structure
This manual contains the following chapters:
Introduction – this chapter provides information about purposes and structure
of the document
InfiLINK XG general description – this chapter contains general description
of InfiLINK XG and functions of its ports
Switch configuration – this chapter provides description of the commands
that are used for switch configuration, as well as configuration examples.
Descriptions include: selection of operation mode, VLAN, STP, QoS settings,
switch statistics collection.
GPS/GLONASS-receiver configuration – this chapter contain descriptions of
the commands for the management by built-in GPS/GLONASS-receiver,
which provide selection of trace level, GPS/GLONASS-receiver statistics and
status.
Modem configuration – this chapter contains descriptions of the commands
for enabling/disabling of radio interface and radio link parameters
configuration:
- selection of node type (Master/Slave), setting of link distance and channel
width, downlink/uplink ratio configuration, settings of central frequencies
and air frame period;
- selection of strategies for traffic prioritization and modulation scheme
selection;
- getting statistics and device configuration review
In addition, this chapter provides step-by-step guidelines for initial
configuration of the devices, their installation and monitoring.
1.2. Document marks
CAUTION
All caution warnings are marked with a special warning sign. One should pay attention to
the content of the Caution section.
HINT
All hints are marked with a special hint sign. Hints usually contain useful comments to
the described section of the document.