User's Manual

Modem configuration

Technical User Manual

InfiLINK XG – CLI commands

- Configure one unit as a Master node and another as a Slave node

- Set channel width, center frequencies and downlink/uplink ratio of

frequency channels, air frame period, maximum distance (well above

estimated link distance), Tx power, etc.

CAUTION

Please note that the following settings must be equal on the both sides of the link:

Link ID

Downlink/uplink frequency channels

Channel width

Downlink/uplink ratio

Air frame period

Otherwise, the units will not link up.

HINT

In order to synchronize the settings of the units, copy from one unit and paste to another

one the Peer exported config lines shown in the xg command outputs. See the

configuration example below.

Configuration example:

#Peer exported config:

xg -appendconf-start

xg -appendconf IC1kbHF1b3RhIDcwIC1zZnJhbWVsZW4gMTAgLW1heC1kaXN0YW5jZSAyNzU

xg -appendconf wIC1ydGctbWFudWFsLWVuYWJsZSAwIC1jZWxsLWlkIDAgLWZyZXEtZGwgNj

xg -appendconf M4MCAtZnJlcS11bCA2MzgwIC10eHB3ciAxNSAtdHhnYWluIC0zMiAtY2hhb

xg -appendconf m5lbC13aWR0aCAxMCAtYW1jLW1vZGUgYXV0byAtYW1jLXN0cmF0ZWd5IGFn

xg -appendconf Z3Jlc3NpdmUgLXRlc3QtYW1jLW9mZnNldCAtMyAtdGVzdC1hbWMtb2Zmc2V

xg -appendconf 0LWVuYWJsZSAxIC1tYXgtbWNzIDkgLXFvcy1zdHJhdGVneSBub3JtYWwgLX

xg -appendconf JsbS12ZXJib3NpdHktbGV2ZWwgMg==.36caaf5c9d9ebc2433482ac4565b

xg -appendconf 241e

xg -appendconf-end

- Save the configuration, reboot both units, and check if they link up after

reboot.

Step 3

Perform initial alignment

- Install both units on the masts and direct them roughly at each other

- Switch them on and check that the wireless link is established, using RF

link led indicators

- Perform rough alignment, using built-in led indicators of signal strength

- Perform fine alignment, using xg stat outputs. Try to maximize CINR and

Absolute RSSI values.