User's Manual

Modem configuration

Technical User Manual

InfiLINK XG – CLI commands

| 2 | QPSK 3/4 | 39137/39137 |86016 |

| 3 | QAM16 1/2 | 52183/52183 |114688 |

| 4 | QAM16 3/4 | 78274/78274 |172032 |

| 5 | QAM64 4/6 | 104366/104366 |229376 |

| 6 | QAM64 5/6 | 130457/130457 |286720 |

| 7 | QAM256 6/8 | 156549/156549 |344064 |

| 8 | QAM256 7/8 | 182640/182640 |401408 |

| 9 | QAM256 30/32 | 195686/195686 |430080 |

| 10 | QAM1024 8/10 | 208732/208732 |458752 |

+---------------+-------------------------------+-------------------------------+-------------------------------+

Lower..upper central frequencies: 4910..5990 MHz

Frequency grid (default): 4920-5980/20 MHz

Frequency list (54 channels):

4920, 4940, 4960, 4980, 5000, 5020, 5040, 5060, 5080, 5100, 5120, 5140, 5160, 5180, 5200, 5220,

5240, 5260, 5280, 5300, 5320, 5340, 5360, 5380, 5400, 5420, 5440, 5460, 5480, 5500, 5520, 5540,

5560, 5580, 5600, 5620, 5640, 5660, 5680, 5700, 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860,

5880, 5900, 5920, 5940, 5960, 5980 MHz

In order to view the configuration of the local unit, use the command:

xg config –self

In order to view the configuration of the remote unit, use the command:

xg config -peer-exported

The outputs of the command can be used for synchronization of the settings on the

unit (see 1.4.2. Initial configuration, installation and monitoring guidelines for

details).

The outputs have the following view:

xg -appendconf-v2-start

xg -appendconf-v2 <encoded web config>

xg -appendconf-v2-end

In order to view the default configuration, use the command:

xg config –defaults

5.2. Initial configuration, installation and

monitoring guidelines

Step 1

Perform site survey

- Determine line of sight conditions and obstacles along the path

- Perform spectrum analysis in order to estimate its occupation and

interference situation and to determine available channels

- Use available link planning tools to estimate link performance and

required configurations for antennas, to choose channel width, Tx power,

etc.

Step 2

Pre-configure the units in the lab