User's Manual

Modem configuration
Technical User Manual
InfiLINK XG – CLI commands
16
If you need to configure downlink center frequency (applicable to the models
supporting split-frequency/H-FDD operation), use the command:
xg -freq-dl {channel-width==10:4905..5995/10 | channel-
width==20:4910..5990/10 | channel-width==40:4920..5980/20}
The range of available values and increment size for each of the channel widths is
specified in braces.
Example:
xg -freq-dl 5200
In order to configure uplink center frequency (applicable to the models
supporting split-frequency/H-FDD operation), use the command:
xg -freq-ul {channel-width==10:4905..5995/10 | channel-
width==20:4910..5990/10 | channel-width==40:4920..5980/20}
The range of available values and increment size for each of the channel widths is
specified in braces.
Example:
xg -freq-ul 5400
If you need to configure downlink/uplink center frequency (sets the same
frequency channel to both uplink and downlink), use the command:
xg -freq
Example:
xg -freq 5200
If you need to set the limits on the available operation frequencies (for example, if
there are some legal or other restrictions for usage of some part of hardware
supported frequencies), you can configure a custom frequency grid.
In order to set a custom frequency grid (within physical/license limits of a specific
model), define the grid individually for each band of each carrier as a list of sub-
bands, using the command:
xg [-grids-carrier-ix=<grids-carrier-ix>] [-grids-band=<grids-band>] -grids
{<freq_start>[-<freq_end>[/<step>]],...}
or as a sequence of frequencies:
xg [-grids-carrier-ix=<grids-carrier-ix>] [-grids-band=<grids-band>] -
grids=