User's Manual

GPS/GLONASS-receiver configuration

Technical User Manual

InfiLINK XG – CLI commands

LAT/LONG — geographical coordinates of the receiver in degrees

- LAT (latitude) — latitude from -90.0000000° to +90.0000000°

- LONG (longitude) — longitude from -180.0000000° to +180.00000°;

Altitude — altitude in meters;

HDOP — horizontal dilution of precision;

CAUTION

It is recommended to use values of “HDOP” parameter up to 1.5 for reliable global timing

synchronization)

current position-fix status in the following view: <current fix mode>,

<system>. The following values of <current fix mode> are available:

- NO FIX - coordinates are not fixed,

- 2D – only latitude and longitude are fixed,

- 3D – latitude, longitude and altitude are fixed;

The following values of <system> (currently used GNSS) are available:

- GPS,

- GLONASS,

- GPS+GLONASS;

The next block of information is the statistics (to obtain these data without

information about status of GPS/GLONASS-receiver you can use gps stat

command instead).

Total GPS time — total time of GPS utility operation since it was started by

gps start command

Total nonvalid time – total time during which the information about

coordinates was unavailable

Number of losses — quantity of cases when the information about

coordinates had become unavailable

Now coordinates are valid last … - time of GPS utility operation since last

coordinates discovering.

Satellites histogram - the histogram of visible satellites quantity.

SATmin и SATmax — minimum and maximum of visible satellites

respectively (since the last time you cleared the statistics).