User's Manual

GPS/GLONASS-receiver configuration
Technical User Manual
InfiLINK XG – CLI commands
10
4. GPS/GLONASS-receiver configuration
4.1. Command description
4.1.1. GPS command
Use this command to handle the GPS/GLONASS-receiver.
Syntax:
#1> gps [options] [command]
Options:
-t=<level> - turn trace level (1, 2 or 0 - turn trace off)
-a[=(0:1)] - turn the power on the antenna amplifier
-r[=(0:1)] - set reset signal
-p=<port> - set TCP port for service (2323 by default)
-s=<baudrate|0> - set baud rate for GPS NMEA port (0 - set 115200)
Command:
start - start GPS service
stop - stop GPS service
coordinates - show GPS coordinates
console - map GPS NMEA port to stdin/stdout
tcp - map GPS NMEA port to TCP service
stat - show GPS statistics
clear - clear GPS statistics
Options:
If you need to configure event logging, you can choose the required trace level,
using the following option:
-t=<level>
The following trace levels are available (from maximum to minimum details):
- Level 2 – to log all the NMEA-messages from the GPS/GLONASS-
receiver.
- Level 1 – to log only the messages about discovering / loss of the
GPS/GLONASS-receiver, about the changing of the quantity of detected
satellites or about substantial changes of coordinates, etc.
- Level 0 – event logging is off.
If you need to enable / disable the power supply to the antenna amplifier (if one is
available), you can set the corresponding value, using the following option:
-a[=<value>]
- <value>=1 – to enable the power supply (is used by default, if the value is
not specified)
- <value>=0 – to disable the power supply