User's Manual

Switch configuration

Technical User Manual

InfiLINK XG – CLI commands

In order to display statistics for the port, use the command:

port [PORT_SET] stat

In order to clear statistics for the port, use the command:

port [PORT_SET] clear

If you want to view the VLAN-based switching matrix, STP status and VLAN

priorities, use the command:

port vtt

If you want to view the information about operation of STP in the selected VLAN

and on each of the associated ports, use the command:

port stt [VID]

Example:

#1> port stt 30

STP state of VID 30:

ID: 100000043507A2A5 Priority: 4096 ID ext: -1

ROOT: 100000043507A2A5 Priority: 4096 ID ext: 0

Ports:

Name Prio Cost PVer Role State

====== ==== ========== ==== ========== ==========

ge1 128 55 RSTP DISABLED DISCARDING

sfp 128 55 RSTP DISABLED DISCARDING

If you want to view MAC-addresses in the switching matrix (FDB) of the selected

port, use the command:

port [PORT_SET] fdb-show

In order to view general information about the port operation: traffic shaper limits,

QoS policy, port status, and data transfer rate, use the command:

port [PORT_SET] dump

Example:

#console>port dump

Port R-limit QOS Mode Link Speed

==== ======= ======== ==== =========

0 ------- wrr UP 100 Mbps

1 ------- wrr down

s ------- wrr down

r 140 wrr UP 26 Mbps

m ------- wrr ---- ---------

3.3. Configuration examples

Configure the switch for operation in isolate mode. It is the default mode. If you

need to switch from transparent mode, use the command:

port -scheme= isolate