User's Manual

Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
86
and v.2c only)
The default SNMP v.1 and v.2c community name is
"public"
It is a security method for SNMP v.1 and v.2c, as Agents
can be set to reply only to queries received by accepted
community names
In SNMP v.1 and v.2c the community name passes
along with the data packet in clear text
Contact
Set the contact information
Used as a reference information about the device owner
Location
Set the geographical location where the unit is installed
Used as a reference information about physical device’s
location
User Name
Set the authorization user name of SNMP v.3
Password
Set the authorization password of SNMP v.3
Security
Set the security level:
- the lowest level means no authentication or privacy
(No Authorization No Privacy), you have to set the
User Name only
-
the medium level means authorization and no
privacy (Authorization No Privacy), you have to set
User Name and Password
-
the highest level means authorization and privacy
(Authorization and Privacy), you have to set the
User Name, Password and Privacy Password
Read only
Enable/disable the read-only permission
Read/Write is the default value
Admin
Enable/disable the full access to the variables
For example, the ability to reboot the device
Limited access is the default value
Privacy
Password
Set the privacy password
It is necessary when privacy is enabled for the required
security level
Privacy
Protocol
Set the encryption method for SNMP v.3: DES/AES128