User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
84
Figure 65 - Adding a management IP address and associate it with VLAN 100
2. Click on the “Apply” button to save the changes
3. Go to the Switch menu page and enable VLAN-based switching:
4. Add VLAN 100 and allow it to pass through the mgmt and radio ports. This
way, the management will be enabled over the air using VLAN 100
5. The default VLAN cannot be removed, so it is necessary to set it off on all the
ports in order to deny access using untagged traffic (“native”) or traffic tagged
with VLAN 1
6. Add VLAN 200 for the data traffic and allow it to pass through the ge0 and
radio ports. Since management is not allowed on VLAN 200, it should be set
to “off” at the mgmt port
7. Mark Access checkbox for ge0 in order to remove all tags for traffic to
customer’s LAN
Figure 66 - VLAN-based switching configuration
8. Click on the “Apply” button to save the changes
At this point, the access to the unit is allowed using only VLAN 100 and the newly
assigned IP address. Traffic tagged with VLAN 200 will be received by rf port and
switched untagged to customer’s LAN through ge0 port.