User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
79
Figure 56 - Configuring per-VLAN 802.1p priorities
Port state: allows you to specify if a VLAN should be allowed to pass by the
port (“on” option), denied (“off”) or if the VLAN should be a native one for the
specific port (“native” option). Only one native VLAN per port.
Figure 57 – Different port state values
5.6.5.3. Configuring native VLAN
A port that is set to the trunk operational mode allows only tagged traffic to pass.
However, one of the VLANs allowed to pass through that port can be configured as
native VLAN and it will be the only VLAN that will allow to pass all the untagged
traffic at the reception. Therefore, the native VLAN will pass both tagged and
untagged traffic.
To be noted that there can be maximum one native VLAN for each port!
The Default VLAN or VLAN 1 is by default configured as native VLAN for all the
ports:
Figure 58 - Default native VLAN configuration