User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
76
5.6.5.1. Management VLAN configuration
It is possible to add management VLAN configuration and to keep transparent
Layer2 bridging operational. It is the simpliest and sufficient configuration for vast
number of cases.
Go to the Network Access menu page in the Web interface. Add the
management IP address and associate it with VLAN 100 (example):
Figure 52- Adding a management IP address and associate it with VLAN 100
Click on the “Apply” button to save the changes
NOTE
Now, our InfiLINK XG has two management interfaces:
10.10.10.10 for untagged frame
10.10.20.1 for VLAN 100
All frames with any VLAN tags will be transparently switched through link
Security considerations imply to remove management interface for untagged
frames, leaving only management VLAN access operational.
Meanwhile, such simple, yet efficient configuration do not allow to restrict any other
VLAN transport except management VLAN.
In order to allow switching of selected VLANs only, please proceed to next
chapters.