User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
71
5.6.4. Switch
The switch page allows you to configure the ports of the unit and the switching
related features.
GE0
I/Q
GE1
External ports
Internal ports
MGMTRADIO
7 port managed
Ethernet switch
Application
processor
(OS WANFleX)
Modem
Control
path
Datal
path
Transceiver
External ports
RADIO
InfiLINK XG unit
SFP
Figure 45 - InfiLINK XG block diagram
NOTE
Please make the distinction between the internal RADIO port of the Ethernet switch
used for the data path separation and the external RADIO port of the unit.
The following 5 ports are available at InfiLINK XG:
GE0 and GE1 ports - external copper Gigabit Ethernet ports 1000BASE-T
(IEEE 802.1ab)
SFP port - external optical Gigabit port for plugging of the optical SFP
transceiver module
RADIO port - internal radio interface of the device
MGMT port - internal interface for the device management.