User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
61
«Reboot» button - reboots the device. A warning message pops up asking for
confirmation before the operation can start. During the restart process, you are
redirected to the login page and the timeout period of 45 seconds counts down
before the new login:
Figure 37 - Unit reboot
«Restore Factory Settings» button - restores the factory default configuration.
A warning message pops up, asking for the permission before the operation to
start. During the reset to factory process, you are redirected to the login page
and the timeout period of 30 seconds counts down before the new login
«View Current License» button - shows the currents device license
parameters in a new window
«View Current Configuration» button - shows the currents device configuration
in text format in a new window
«Create Diagnostic Card» button - Tech Support Reports Generator. By
clicking on this button, the system downloads to the local PC a text file that
contains the complete information (for the technical support specialists) set
from the device such as: full device configuration listing, system log output,
license information, interfaces statistics, etc.
Figure 38 - How to create a diagnostic card