User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Configuration
Technical User Manual
InfiLINK XG
55
5.4. Antenna alignment
The graphical antenna alignment tool allows to visualize the signal characteristics
on both sides of the link in order to make the antenna alignment process more
accurate and easier.
The accuracy of the antenna alignment at the neighbor device is very important for
the link quality.
By clicking the «Start Test»/«Stop Test» buttons at the bottom of the page, you
can start/stop the alignment test.
By clicking the «Clear History» button, you delete all data stored from the moment
you clicked the «Start Test» button.
Once the test is started, the antenna alignment can be monitored using the graphic
and text indicators. The indicators for both local and remote devices are displayed
together in the same page which allows viewing the alignment process for both
sides of the link.
Each side of the link (local and remote) has two similar test indicator sets,
corresponding to each antenna polarization (one for Vertical polarization and
another for Horizontal). This allows controlling the alignment process for each
antenna polarization for the local and for the remote device simultaneously.
Figure 32 - Antenna alignment tool