User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Installation
Technical User Manual
InfiLINK XG
39
between bottom LPU and IDU. Keep most of the IDU-ODU STP cable length
between the two LPU devices.
3.3.8. Antenna Alignment
Prior to the antenna alliagnment activity, perform the radio planning activity using
either InfiNet Wireless Link Planner tool (
http://linkplanner.infinetwireless.com),
your own RF planning tool or ordering InfiNet Wireless Professional Services.
To obtain maximum system performance, antennas must be precisely aligned
towards one another according to LOS requirements. General recommendations
for antenna alignment are as follows:
Align antennas using optical equipment (binoculars, spyglass) accompanied
by mobile phone actions coordination;
Use GPS receiver, compass and area map;
Use build-in InfiNet Wireless Device features. These features allow for the
evaluation of the current channel and signal quality and are a powerful aid in
performing precise antenna alignment.
Antenna polarization must be taken into account while installing. Please check the
corresponding labeling on the antenna and refer to the antenna technical
documentation.
3.4. Installing the Indoor Unit
Shielded RJ45
connector
Unshielded
RJ45 connector
AC
LAN
STP Cat5e cable
Figure 25 - Connection Scheme for IDU-BS-G