User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 3 - Installation
Technical User Manual
InfiLINK XG
32
than 100 meters. Service cable connecting IDU and ODU should be STP Cat
5E cable
4. If using SFP module, connect it to ODU, plug in the optical cable (the
maximum length and type depend on the SFP module type) and seal the
connector
Figure 16 - InfiLINK XG - Xm ODU Installation Procedure
1. Cable gland nut
2. Split sealing grommet
3. Cable gland threaded coupling
4. Optical cable (from 2mm to 3 mm)
5. SFP-module (not included in the delivery package)
6. Standard RJ-45 connector
7. GPS antenna port (antenna and cable are not included in the delivery package)
8. Grounding bolt
5. Install (crimp) regular RJ-45 connector for ODU on the STP cable and seal it.
Do not use the shielded RJ-45 connector on this end of the cable, as it should
be attached only on the IDU end
6. Lay the STP cable (and the optical cable, if used) “from top to bottom” - from
ODU to IDU
7. Install (crimp and solder) shielded RJ-45 connector for IDU on the STP cable
8. Install ODU on the mounting bracket, connectors facing down, and tighten it
NOTE
It is very important to mount the ODU connectors facing down.
9. Connect the ODU-IDU cable to the ODU
10. Seal the ODU Ethernet connectors