User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 2 - System Description
Technical User Manual
InfiLINK XG
17
Parameter Description
Automatic
Modulation
Control
Supported
Automatic
Ranging
Supported
TDD
Synchronizatio
n
Via built-in GLONASS/GPS receiver or IEEE1588 PTP
Table 11 - Air Protocol Specification
2.3.3. Data Communication
Parameter Description
Ethernet
2x 10/100/1000-BaseT copper ports, RJ-45:
- GE0: Data+PoE input
- GE1: Data only
SFP port: various 3
rd
party single and multi-mode fiber
modules are supported
Either of the ports can be configured independently for
management, user data or for a hybrid mode
PoE
802.3at or InfiNet-proprietary “passive” PoE
Cable Length
Copper Ethernet cable length: up to 100
m between
outdoor unit and the primary network connection
Fiber cable length: up to 300 m or more depending on
the SFP module type
Table 12 - Wired Interfaces Specification
Parameter Description
QoS
4 queues
Prioritization
Strict and WRR modes
Packet
Classification
802.1 p
Network
Protocols
VLAN, STP, IGMP