User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 2 - System Description
Technical User Manual
InfiLINK XG
12
2.2.3.2. External Lightning Protection (AUX-ODU-LPU-
G)
Figure 5 - AUX-ODU-LPU-G Front Panel
Optional indoor/outdoor Lightning Protection Unit (LPU) for InfiNet Wireless
systems designed to withstand the toughest conditions and protect the outdoor or
the indoor unit from sudden power surges induced by lightning strikes. It provides
the same level of protection as AUX-ODU-INJ-G.
Despite the fact every InfiNet Wireless unit has a built-in lightning protection, AUX-
ODU-LPU-G, thanks to its superior GR-1089-grade protection, greatly reduces the
risk of replacing damaged devices operating in harsh environments or difficult-to-
reach locations.
Parameter Description
Size and Weight
34x94x121 mm, 0.28 Kg
Connectors and
Interfaces
ETH IN - Ethernet input
ETH OUT - Ethernet output (protected leg)
GND - ground clamp
Supported
Ethernet Modes
10/100/1000 Mbps (Gigabit Ethernet pass-through)
Water and Dust
Protection
IP66 and IP67