User's Manual
Table Of Contents
- FCC and IC Statement
- Getting started
- 1.1. Document structure
- 1.2. Abbreviations
- 1.3. Document marks
- System Description
- 2.1. Introducing InfiLINK XG
- 2.2. Hardware Description
- 2.3. InfiLINK XG Specifications
- Installation
- 3.1. Installation Requirements
- 3.2. Equipment Positioning Guidelines
- 3.3. Installing the Outdoor Units
- 3.4. Installing the Indoor Unit
- Commissioning
- 4.1. Introduction
- 4.2. Step by step procedure
- Operation & Administration
- 5.1. Introduction
- 5.2. InfiLINK XG unit access
- 5.3. Status
- 5.3.1. Interface Statistics
- 5.3.2. Wireless Link Statistics
- 5.4. Antenna alignment
- 5.5. Maintenance
- 5.5.1. Firmware
- 5.5.2. Upload
- 5.5.3. Download
- 5.5.4. Bottom section of the page
- 5.6. Settings
- 5.6.1. General
- 5.6.2. Network Access
- 5.6.3. Radio
- 5.6.4. Switch
- 5.6.5. VLAN Switching
- 5.6.6. SNMP
- 5.6.7. Apply and Try buttons for the configuration
- 5.6.8. Configuring QoS
- 5.6.9. Configuring per-VLAN 802.1p priority assignment
- Troubleshooting
- 5
- 6.1. Introduction
- 6.2. The wireless link is down (it got lost)
- 6.3. No access to the local unit
- 6.4. Expected capacity is not met
- 6.5. Errors on the wireless link, throughput fluctuations
- 6.6. No data is being transferred
- 6.7. The management of the unit is lost
- 6.7.1. ERConsole recovery procedure
- 6.7.2. Restore to factory settings using ERConsole
Chapter 2 - System Description
Technical User Manual
InfiLINK XG
8
2.2.2. Power Supply Units (IDU)
2.2.2.1. IDU-BS-G
Power indicator
Figure 1 - IDU-BS-G Top View
Indoor Gigabit PoE Injector with lightning protection for InfiLINK XG, InfiLINK 2x2
and InfiMAN 2x2 series ODU.
Parameter Description
Size
125*72*38 mm (L*W*H)
Connectors and
Interfaces
ETH IN - Ethernet input (Data only)
ETH OUT - Ethernet output (Data+VDC), PASSIVE PoE
PWR - AC Input (100-240 V)
Supported
Ethernet Modes
10/100/1000Mbps (Gigabit Ethernet pass-through)
Output Voltage
& Current
+56 V, 0.9 A (50.4W Max)