User's Manual

InfiNet Wireless R5000 Technical User Manual

rfX Settings - RF interface settings (e.g. rf5.0):

Please see ―ethX Settings‖ description above.

prfX Settings – Pseudo-RF interface settings (e.g. prf0):

IW units can establish connections with each other not only via radio but

also through wired Ethernet. PRF (Pseudo-RF) interface is used for this

purpose. PRF interface makes Ethernet interface look like a usual radio

interface through which a node can find neighbors and establish a

connection with them.

Please see the full description of the PRF interface in OS WANFleX User

Manual.

For ―Up‖, ―DHCP‖ and IP-address settings please see ―ethX Settings‖

description above.

―Parent‖ check-box allows connects the PRF interface with the physical

interface of the device.

―Channel‖ field allows setting channel number with which the frames are

sent and received by the parent interface. Frames sent to Ethernet with

a specific channel number can be received on other nodes only by its

PRF interfaces with the same channel number. Possible channel values

are 0-3.

vlanX Settings – VLAN IEEE 802.1q settings (e.g. vlan0):

For ―Up‖, ―DHCP‖ and IP-address settings please see ―ethX Settings‖

description above.

―Parent‖ check-box connects the VLAN interface with the physical interface

of the device.

―VLAN ID‖ field allows setting the VLAN tag for the current interface (1-

4094)

―QinQ‖ check-box enables dot1q tunneling (double-tagging) on the

interface.

lagX Settings – Ling Aggregation interface settings (e.g. lag0):

Link aggregation is using multiple physical channels in parallel as one

logical channel to increase the total capacity of the link and provide

redundancy. To perform this functionality on the unit ―lagX‖ logical

interface is used.

For ―Up‖, ―DHCP‖ and IP-address settings please see ―ethX Settings‖

description above.

―Add parents‖ button allows of choosing the parent physical interfaces for

the aggregation.

Default Gateway – sets an IP-address for the Default Gateway.

―Create Pseudo-RF‖, ―Create VLAN‖ and ―Create LAG‖ buttons creates the

corresponding interfaces in the configuration of the unit.