Datasheet

CoolSET
®
-F3
ICE3A1065ELJ
Electrical Characteristics
Version 2.3 19 19 Nov 2012
4 Electrical Characteristics
Note: All voltages are measured with respect to ground (Pin 8). The voltage levels are valid if other ratings are
not violated.
4.1 Absolute Maximum Ratings
Parameter Symbol Limit Values Unit Remarks
min. max.
Drain Source Voltage V
DS
- 650 V T
j
=110°C
Pulse drain current, t
p
limited by max.
T
j
=150°C
I
D_Puls
- 3.4 A
Avalanche energy, repetitive t
AR
limited
by max. T
j
=150°C
1)
1)
Repetitive avalanche causes additional power losses that can be calculated as P
AV
=E
AR
*f
E
AR
- 0.07 mJ
Avalanche current, repetitive t
AR
limited
by max. T
j
=150°C
I
AR
- 1.0 A
VCC Supply Voltage V
VCC
-0.3 27 V
FB Voltage V
FB
-0.3 5.5 V
BL Voltage V
FB
-0.3 5.5 V
CS Voltage V
CS
-0.3 5.5 V
Junction Temperature T
j
-40 150 °C Controller & CoolMOS
®
Storage Temperature T
S
-55 150 °C
Thermal Resistance
Junction -Ambient
R
thJA
- 90 K/W PG-DIP-8
Soldering temperature, wavesoldering
on
ly allowed at leads
T
sold
- 260 °C 1.6mm (0.063in.) from case
for 10s
ESD Capability (incl. Drain Pin) V
ESD
- 2
2)
2)
2KV is for all pin combinations except VCC to GND is 1KV
kV Human body model
3)
3)
According to EIA/JESD22-A114-B (discharging a 100pF capacitor through a 1.5kΩ series resistor)
Note: Absolute maximum ratings are defined as ratings,
which when being exceeded may lead to destruction
of the integrated circuit. For the same reason make sure, that any capacitor that will be connected to pin 7
(VCC) is
discharged before assembling the application circuit.T
a
=25°C unless otherwise specified.