Datasheet

CCM-PFC
ICE2PCS02/G
Functional Description
Version 2.4 9 22 Mar 2010
3.4.2 Soft Over Current Control (SOC)
The IC is designed not to support any output power
that corresponds to a voltage lower than -0.75V at the
ISENSE pin. A further increase in the inductor current,
which results in a lower ISENSE voltage, will activate
the Soft Over Current Control (SOC). This is a soft
control as it does not directly switch off the gate drive.
It acts on the nonlinear gain block to result in a reduced
PWM duty cycle.
Figure 8 SOC and PCL Protection as function of
V
ISENSE
The rated output power with a minimum V
IN
(V
INMIN
) is
Due to the internal parameter tolerance, the maximum
power with V
INMIN
is
3.4.3 Peak Current Limit (PCL)
The IC provides a cycle by cycle peak current limitation
(PCL). It is active when the voltage at pin 3 (ISENSE)
reaches -1.04V. This voltage is amplified by OP1 by a
factor of -1.43 and connected to comparator C2 with a
reference voltage of 1.5V as shown in Figure 9. A
deglitcher with 300ns after the comparator improves
noise immunity to the activation of this protection.
Figure 9 Peak Current Limit (PCL)
3.4.4 Open Loop Protection (OLP)
Whenever VSENSE voltage falls below 0.6V, or
equivalently V
OUT
falls below 20% of its rated value, it
indicates an open loop condition (i.e. VSENSE pin not
connected) or an insufficient input voltage V
IN
for
normal operation. In this case, most of the blocks within
the IC will be shutdown. It is implemented using
comparator C3 with a threshold of 0.6V as shown in the
IC block diagram in Figure 2.
3.4.5 Over-Voltage Protection (OVP)
Whenever V
OUT
exceeds the rated value by 5%, the
over-voltage protection OVP is active as shown in
Figure 6. This is implemented by sensing the voltage at
pin VSENSE with respect to a reference voltage of
3.15V. A VSENSE voltage higher than 3.15V will
immediately reduce the output duty cycle, bypassing
the normal voltage loop control. This results in a lower
input power to reduce the output voltage V
OUT
. A
VSENSE voltage higher than 3.25V will immediately
turn off the gate, thereby preventing damage to bus
capacitor.
3.5 Fixed Switching Frequency
ICE2PCS02/G has an internally fixed switching
frequency as opposed to the ICE2PCS01/G which can
be externally set. This frequency is trimmed to 65kHz
with an accuracy ±5% at 25
o
C.
V
ISENSE
-0.61V -0.75V -1.04V
Normal
Operation
SOC PCL
P
OUT
(rated)
IC’s
State
0
P
OUT
(max)
P
OUT
rated( ) V
INMIN
0.61
R1 2×
-------------------
´=
P
OUT
max( ) V
INMIN
0.75
R1 2×
-------------------
´=
ISENSE
ICE2PCS02/G
R1
R2
I
INDUCTOR
OP1
1.43x
Current Limit
300ns
C2
Deglitcher
Turn Off
Driver
1.5V
Full-wave
Rectifier