Datasheet

BTS5045-2EKA
General Product Characteristics
Data Sheet 10 Rev. 2.1, 2011-09-01
PROFET™+ 12V
Notes
1. Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
2. Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are not
designed for continuous repetitive operation.
Maximum energy dissipation
Single pulse (one channel)
E
AS
––35mJI
L(0)
= 4 A
T
J(0)
= 150 °C
V
S
= 13.5 V
P_4.1.23
Voltage at power transistor
V
DS
– – 41 V – P_4.1.26
Currents
Current through ground pin
I
GND
-10
-150
–10
20
mA –
t < 2 min
P_4.1.27
Temperatures
Junction temperature
T
J
-40 – 150 °C – P_4.1.28
Storage temperature
T
STG
-55 – 150 °C – P_4.1.30
ESD Susceptibility
ESD susceptibility (all pins)
V
ESD
-2 – 2 kV
5)
HBM P_4.1.31
ESD susceptibility OUT Pin
vs. GND and
V
S
connected
V
ESD
-4 – 4 kV
5)
HBM P_4.1.32
ESD susceptibility
V
ESD
-500 – 500 V
6)
CDM P_4.1.33
ESD susceptibility pin
(corner pins)
V
ESD
-750 – 750 V
6)
CDM P_4.1.34
1) Not subject to production test. Specified by design.
2) Hardware set-up in accordance to AEC Q100-012 and AEC Q101-006.
3)
V
S(LD)
is setup without the DUT connected to the generator per ISO 7637-1.
4) EOL tests according to AECQ100-012. Threshold limit for short circuit failures: 100 ppm. Please refer to the legal disclaimer
for short-circuit capability on Page 54 of this document.
5) ESD susceptibility HBM according to EIA/JESD 22-A 114B.
6) “CDM” EIA/JESD22-C101 or ESDA STM5.3.1
Table 2 Absolute Maximum Ratings (cont’d)
1)
T
J
= -40°C to +150°C; (unless otherwise specified)
Parameter Symbol Values Unit Note /
Test Condition
Number
Min. Typ. Max.