Datasheet

BTM7811K
Data Sheet 10 Rev. 1.0, 2008-05-15
5 Electrical Characteristics
5.1 Absolute Maximum Ratings
Note: Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
Note: Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are
not designed for continuous repetitive operation.
Absolute Maximum Ratings
1)
-40 °C < T
j
< 110 °C; all voltages with respect to ground, positive current flowing into pin (unless otherwise
specified)
1) Not subject to production test; specified by design
Pos. Parameter Symbol Limit Values Unit Remarks
min. max.
High-Side-Switches (Pins DHVS, IH1,2 and SH1,2)
5.1.1 Supply voltage
V
S
– 0.3 42 V –
5.1.2 Supply voltage for full short circuit
protection
V
S(SCP)
–28V
5.1.3 HS-drain current
2)
2) Single pulse
I
S
– 14
3)
3) Internally limited
A T
A
= 25°C; t
P
< 100 ms
5.1.4 HS-input current
I
IH
– 5 5 mA Pin IH1 and IH2
5.1.5 HS-input voltage
V
IH
– 10 16 V Pin IH1 and IH2
Status Output ST
5.1.6 Status pull up voltage
V
ST
– 0.3 5.4 V
5.1.7 Status Output current
I
ST
– 5 5 mA Pin ST1 or ST2
Low-Side-Switches (Pins DL1,2, IL1,2 and SL1,2)
5.1.8 Drain-Source-Clamp voltage
V
DSL
55 – V V
IL
=0V; I
D
≤ 1mA
T
j
= 25°C
5.1.9 LS-drain current
2)
I
DL
– 21 26 A T
A
= 25°C; t
P
< 100 ms
5.1.10 – 42 A
T
A
= 25°C; t
P
< 10 ms
5.1.11 – 67 A
T
A
= 25°C; t
P
< 1 ms
5.1.12 LS-input voltage
V
IL
– 20 20 V Pin IL1 and IL2
Temperatures
5.1.13 Junction temperature
T
j
– 40 110 °C–
5.1.14 Storage temperature
T
stg
– 55 150 °C–
ESD Protection
4)
4) ESD susceptibility HBM according to EIA/JESD22-A114-B (1.5kΩ, 100pF)
5.1.15 Input LS-Switch V
ESD
–0.5kV
5.1.16 Input HS-Switch
V
ESD
–1kV
5.1.17 Status HS-Switch
V
ESD
–2kV
5.1.18 Output LS and HS-Switch
V
ESD
– 4 kV all other pins connected
to Ground