Datasheet

AUIPS6041(G)(R)(S)
www.irf.com
3
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters
are referenced to Ground lead. Tj= -40°C..150°C, Vcc=6..35V (unless otherwise specified).
Symbol
Parameter
Min.
Max.
Units
Vout
Maximum output voltage
Vcc-35
Vcc+0.3
V
Voffset
Maximum logic ground to load ground offset
Vcc-35
Vcc+0.3
Vin
Maximum input voltage
-0.3
5.5
Vcc max.
Maximum Vcc voltage

36
Vcc cont.
Maximum continuous Vcc voltage

28
Iin max.
Maximum IN current
-3
10
mA
Idg max.
Maximum diagnostic output current
-3
10
Vdg
Maximum diagnostic output voltage
-0.3
5.5
V
Pulse 2a max
Maximum voltage ISO pulse 2a x 500cy (ISO7637)

55
V
Pd
Maximum power dissipation (internally limited by thermal protection)

1.25
W
Rth=100°C/W AUIPS6041G
Rth=50°C/W AUIPS6041R 1”sqrt. footprint

2.5
Tj max.
Max. storage & operating temperature junction temperature
-40
150
°C
Thermal Characteristics
Symbol
Parameter
Typ.
Max.
Units
Rth1
Thermal resistance junction to ambient AUIPS6041G
100

°C/W
Rth1
Thermal resistance junction to ambient AUIPS6041R D-Pak std. footprint
70

Rth2
Thermal resistance junction to ambient AUIPS6041R D-Pak 1” sqrt.
footprint
50

Rth3
Thermal resistance junction to case AUIPS6041(R)(S)
D-Pak/D2pak/TO220
6

Rth1
Thermal resistance junction to ambient AUIPS6041(S) D2Pak/TO220 std.
footprint
60

Rth2
Thermal resistance junction to ambient AUIPS6041S D2Pak 1” sqrt.
footprint
40

Recommended Operating Conditions
These values are given for a quick design. For operation outside these conditions, please consult the application notes.
Symbol
Parameter
Min.
Max.
Units
VIH
High level input voltage
4
5.5
VIL
Low level input voltage
0
0.9
Iout
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
A
Rth=100°C/W AUIPS6041G

1.6
Rth=50°C/W AUIPS6041R 1” sqrt. footprint

2.3
Rin
Recommended resistor in series with IN pin
4
10
k
Rdgs
Recommended resistor in series with DG pin for reverse battery protection
4
20
Rdgp
Recommended pull-up resistor for DG
4
20
Rol
Recommended pull-up resistor for open load detection
5
100
F max.
Max. switching frequency

3.5
kHz