User's Manual

Reference design 60 GHz radar FF module

User manual and integration instructions

FCC considerations

5 FCC considerations

The reference module has been certified at FCC according to the rules as stated in chapter 5.1.

Host product manufacturers must immediately file a 2.933 Change-in-ID application to obtain their own FCC ID

for the module, and then a C2P application to authorize the module in their specific host device(s).

Host product manufacturers are advised to carefully read the whole of chapter 5 and follow the guidelines

according to KDB 996369 D04, or the latest updates of it.

5.1 List of applicable FCC rules

The modular transmitter was tested according to the following rules:

 FCC Rules and Regulations Part 15, Subpart A – General (September 2019)

 Part 15, Subpart A, Section 15.31 Measurement standards

 FCC Rules and Regulations Part 15, Subpart C – Intentional Radiators (September 2019)

 Part 15, Subpart C, Section 15.203 Antenna requirements

 Part 15, Subpart C, Section 15.204 External radio frequency power amplifiers and antenna

modifications

 Part 15, Subpart C, Section 15.205 Restricted bands of operation

 Part 15, Subpart C, Section 15.207 Conducted limits

 Part 15, Subpart C, Section 15.209 Radiated emission limits, general requirements

 Part 15, Subpart C, Section 15.255 Operation within the band 57 to 71 GHz.

The modular transmitter is only FCC authorized for the specific rule parts listed on the grant. The host product

manufacturer is responsible for compliance with any other FCC rules that apply to the host not covered by the

modular transmitter grant of certification.

5.2 Specific operational use conditions

 The module is classified for use in fixed equipment, refer to chapter 5.5.

 The module is FCC- certified for the operating frequency range 61 to 61.5 GHz.

 The application software (SW) has the firmware (FW) ID 1.0.0.

5.3 Limited module procedures

The modular transmitter is approved by FCC as a “limited module” due to the following limitations:

 The module does not have its own RF shielding.

 The module does not have an FCC ID label attached to it.

FCC ID: 2AYSQ-6011