Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 94
The "Auto Refresh" option is disabled by default. You can enable the auto refresh in order to have the statistics
automatically refreshed.
7.2.6.2 Switch VLAN Statistics
The "Switch VLAN Statistics" tool gathers complete information and enhanced statistics for each VLAN created:
51 Figure - Switch VLAN Statistics
By clicking the «Close» button you return to the "Device Status" page.
The "Auto Refresh" option is disabled by default. You can enable the auto refresh in order to have the statistics
automatically refreshed.
7.3 Basic Settings
Devicescan be configured via Web interface, or via Command-line interface. The parameters for the majority of the
Command-line interface commands are displayed in the Web interface. Saving the configuration for these
parameters in any of the two interfaces (Command-line and Web) is reflected in both interfaces.
However, for some other commands, the most important parameters can be set via Web interface, but the
enhanced parameters of these commands can be set via Command-line interface only. The commands that do not
have the enhanced parameters displayed in Web interface are: sys, ifconfig, prf, qm, tun, route, mint, switch, svi, lag,
sntp, dhcpc(please consult the information about the Extra commands (see page 138)section within the current
chapter, below).
The settings of these enhanced parameters will be lost after saving the configuration via Web interface.
The warning message below is displayed in the "Basic Settings" page from the Web interface if the configuration
has been previously created via CLI, in order to avoid losing data for those only few commands that don’t reflect
their parameters in the Web interface:
52 Figure - Basic settings warning message
After performing the needed configuration in the "Basic Settings" menu, you must save all the new parameters by
clicking the «Apply» button. If you are not sure about the effect of the new configuration performed, you can apply
the new configuration temporarily by clicking the «Test» button. The previous configuration is automatically
restored after a grace period of 180 seconds (3 minutes). You have the options to extend the grace period, or
immediately accept/reject the changes.
NOTE
This message is not displayed in the default configuration, but only after the first configuration via CLI.