Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Installation – 54
•
•
Bolt M8x50 - used for installation on a pole with Ø 30 ... Ø 55 mm.
Bolt M8x80- used for installation on a pole with Ø 55 ... Ø 85 mm.
Step 3:Perform required antenna alignment usingadjustment knobs and then tighten nuts M8.
Mounting is carried out on a pole with a diameter 30 ... 85 mm. There are also possible options for mounting on a
wall or pole with a diameter more than 85 mm.
NOTE
M8 nuts are pre-tightened at the manufacturing facility in a position that allows the device to be adjusted
using the adjustment knobs and ensures that the wireless device does not shift during the final nuts
tighten.
NOTE
If further adjustment is required, weaken the nuts M8 on about 15 degrees. Do not adjust the knobs
without weaken the nuts first.