Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
67 mailto:[e-mail]
Troubleshooting – 169
9.
10.
11.
1.
2.
3.
4.
111 Figure - Adding a new IP address
Turn off and onthe InfiNet unit.Waitfor about 30 seconds until the "Complete" sign will uppear.
Add an IP-address from the same network subnet to your PC and access the unit.ERConsole will not show
newly assignedIP-address.
Login to the unit using the newIP-address. Do not reboot the unit now because the IP-address added by
ERConsole is temporar until the new configurationhas been saved.
8.6.2 Restore to factory default settings using ERConsole
If you need to restore your unit to thefactorydefaultsettings, follow the instructions below:
Obtain the IP-address of the unit using the ERConsole as describedin the section above.
Click on the «+» button in the ERConsole application and a new window will appear.
Obtain the Factory Password. In order to do this, please contact the distributor which the device was
purchased from. The request must include the device serial number and thevalue of "Sequence" field (if it's
non-zero).
Select “Reset configuration” option andenterthe Factory Password obtained at the previous step in the
"Factory password" field, then click «OK». The password must be entered the sameformatas it has been
gotit fromthe distributor or IW support (with the gaps).
NOTE
If the management of the unit is lost due to unknown user name or password it can be restored using
factory password. Put an serial number of device in the "User name" field and factory password in the
"Password" field. User's PC and InfiNet unit should belong to the same subnet.

NOTE
In case of purchasing the unit directly in InfiNet Wireless,you may send a request to the InfiNet
Wireless Technical support to[e-mail]
67
. Please be ready to provide a
purchasing confirmation.
