Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
41 ftp://ftp.infinetwireless.com/pub/Firmware
42 https://wiki.infinetwireless.com/display/DR/General+Purpose+Command+Set#GeneralPurposeCommandSet-flashnet
Troubleshooting – 156
•
•
92 Figure - Checking the interface status
If the status of the interface is "Down", enable the radio interface in the "Network settings" section by clicking the
checkbox.
93 Figure - Changing the interface status
If the device does not have a radio interface, the reason for such behavior can be the recovery mode present during
the reset of the device using theERConsole(see page 167).Complete the recovery process by returning the device to
the factory settings from the Maintenance section.
Pay attention to the red values of the parameters in the interface statistics "Mode" column:
Operating frequency - red value of this parameter indicates an absence of data transmission due to the
spectrum scanning by the DFS tool;
TX Power - red value for this parameter may indicate a problem with the transceiver's hardware.
8.2.1.4 Checking the firmware version
Web interface
In the "
Maintenance(see page 139)" section, make sure that the same software version is installed on both device.We
recommend to update the devices to the latest beta software version.
94 Figure - Checking the firmware version
The latest software versions can be downloaded from the official InfinetFTP server
41
.
Command line interface
To upload the software via the command line, use the "flashnet" command described in the"
General Purpose
Command Set
42
" article.