Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Troubleshooting – 152
86 Figure - LED indication of InfiMAN Evoluton ST, InfiLINK Evolution
PWR - power indicators will lightredwhen the device is connected to a power source, yellow when10/100
Mbpswired connection appears and green when 1000 Mbpswired connection appears. Other indicators are used to
perform coarse antenna alignment.The more indicators are on, the better wireless connection is established. The
blinking indicator means an intermediate state. The more often the indicator blinks the higher level connection is
established.
8.1.2 Access recovery
If the power indicator is on and there is connection via the Ethernet interface, connect to the device directly as it is
shown in the scheme below.Make sure that the IP address of the PC is in the same subnet as the IP address of the
device.You can restore the IP address and reset the device to the factory settings using the ERConsole utility.
The factory reset process using the ERConsole is described in the "
Emergence Repair Console(see page 167)" article.
87 Figure - The recommended connection scheme
8.1.3 Checking the status of the Ethernet interface
8.1.3.1 Wired interface statistics
Web interface
If you were able to access the device by connecting directly, try to determine the possible reason for the
unavailability through the network.Pay attention to the wired interface statistics.In order to do this, go to the