Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
32 https://wiki.infinetwireless.com/display/DR/WANFleX+-+Technical+User+Manual
Operation & Administration – 139
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The commands that do not have the enhanced parameters displayed in Web interface are:sys, ifconfig, prf, qm, tun,
route, mint, switch, svi, lag, sntp, dhcpc:
71 Figure - Extra commands
Parameter Description
Command Select the command to add it to the device configuration
Parameters Insert the string to specify the command parameters and options
Please refer to
WANFleX OS User Manual
32
for the full explanation
of all command parameters and options
Disabled Check this option in order to disable the command temporarily
30 Table - Extra commands
"Up/Down" arrows allow you to organize the command list
Click the «Remove Command» button if you want to delete the command from the list permanently
Click the «Add command» button if you want to add the command to the list
In the "Command Line" menu, the commands are only executed, but not saved into the configuration, while in
"Extra commands" section from "Basic Settings" menu, the commands are executed and saved into the
configuration.
7.4 Maintenance menu
The "Maintenance" menu allows you to perform service tasks for the device maintenance and to check the
hardware and software version, reason for the last reboot, system uptime, current configuration, license, diagnostic
card, etc.
"Maintenance" page has the following sections:
Firmware(see page 140)
SSL certificate installation(see page 140)
Firmware update(see page 142)
Mass firmware upgrade(see page 144)
Upload(see page 145)
Download(see page 146)
Bottom section of the page(see page 146)
If any configuration changes are introduced via the Web interface later on, the configuration re-initializes
and all CLI configured parameters are reset to default. Use this section to add CLI specific commands to
the configuration in order to preserve the fine-tuning settings.