Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 110
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Node ID Set the device identification number
The parameter is optional
Node ID can be configured by the administrator for a better
representation of a neighbors table (nodes within a wireless network)
Security Key Set the secret key word for encoding of the protocol messages
It must be up to 64 characters long, without spaces
It must be the same at both ends of the link
14 Table - Radio settings parameters in the time division networks
On each radio profile, the following options are available (for theSlaveunit only):
"Disable profile" check box disable a radio profile
Add a new radio profile by clicking the «Add Profile» button
Copy the radio profile values to a new radio profile by clicking the «Copy» button
Remove the radio profile by clicking the «Remove» button.
Frequency limitation
The licensed frequencies range per each bandwidth is displayed in the "rf6.0" subsection, in “Default Frequency
Grid” fields. Changes to these default values can be performed in the “Customer Frequency Grid” fields; you can:
Limit the licensed frequencies range per each bandwidth (see the screenshot below)
Change the center frequency step (for example: 5920-6040/20 means that the step between the center
frequencies from 5920 GHz and 6040 GHz is 20 MHz).
The changes performed in “Customer Frequency Grid” will be available in the “Frequency” drop down list from the
radio profiles and inDFS(see page 148)page in “Frequency grid” field.
58 Figure - Customer frequency grid
Setting channel type mode
When Channel Type is set to “Single”, thenTxand/orRx of Chain #1(for horizontal polarization antenna) can be
deactivated:
"Chain #0" is connected to the port of the vertical polarized integrated antenna
"Chain #1" is connected to the port of the horizontal polarized integrated antenna