Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
18 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=10780854
19 https://wiki.infinetwireless.com/display/DR/Static+Links
Operation & Administration – 107
•
•
•
•
•
•
•
•
•
Multicast Mode
(Master)
Traffic transmission mode:
"Multicast" - conventional mode that uses modulation one
step lower than the lowest modulation among the traffic
receivers when transmitting the "multicast/broadcast" frames.
In the case of "multicast" streams information from "IGMP
Snooping" module is used to obtain a list of
subscribers.Consequently, thelist of all connected sector
clients is usedfor the "broadcast" traffic.
Transformation of"Multicast" to "Unicast". In case two or
more clients are assigned to the same "multicast" stream a
copy of source stream will be sent to each of them in the
"Unicast" mode.
"Unicast 2", "Unicast 3", "Unicast 4", "Unicast 5"- the
number of subscribers limitation. Conventional
"Multicast" mode will be used when the number is
exceeded.
"Unicast All" - transformation is always executed.
Transformation to "Unicast" requires memory data copying that
increasesCPUload. Besides, the use of "Unicast" streams
increases the volume of transmitted traffic proportional to the
number of subscribers and reduces the sector available
throughput.
Authentication Mode Set the mode:
"static" -the unit can establish connections only with units,
which MAC-addresses are listed in the "Static Links
19
" section
public- the unit can establish connections with any other units
which have the same security key and the corresponding
wireless connection settings
"remote" - centralized authentication mode with remote
server (e.g. RADIUS or relay). In this mode any node can
request the information from a remote authentication server
(remote authentication server parameters are set using “AAA”
command). This means that the node must have an access to
this server (e.g. usingIP)
NOTE
"Unicast 3" mode is set by default.
NOTE
Transformation of"Multicast" to "Unicast" via CLI is described in
the section "mint command
18
".