Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 105
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
DFS
(Master)
Enable/disable DFS
If “DFS only” is set, the DFS system monitors interferences but does
not perform radar detection
If "DFS with Radar Detection" is set, the DFS system monitors
interferences and performs radar detection
For the two radios base stations, the “Instant DFS” option is available
(one of the two radios is used for DFS scanning, Radar detection and
Spectrum analyzing)
Tx Power Set the output power of the radio interface
Acts as a top limit for the output power control if
theATPCmechanism is turned on
Two operating ranges of Tx power are available:
“-10...10” (if chosen top limit is 10 dBm or less)
“0...27” (if chosen top limit is from 10.5 dBm to 27 dBm)
By default, it is turned on (it is strongly recommended to remains
“on”)
The offset parameter is used to adjust the thresholds
Node Name Set the name for this node in the network
By default, it is the "Unknown"node
This node name will appear on the neighbor lists
Scrambling Enable/disable the data scrambling to improve the connection
stability (enabled by default)
Trap gateway Enable/disable gateway forSNMP-traps
Switch border Enable/disable the switch border mode. In this mode the unit
operates as a "borderline" between the MINT domains, i.e. prevents
the distribution of information about the switch groups and data
transfer between these domains, while retaining all the capabilities of
the MINT protocol (obtaining information about the whole MINT
network, sending remote commands etc.)
CAUTION
Please note that, in some countries, switching “DFS off” and/or
failing to detect public service radar signals are against the
regulations and may result in legal action.
