Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
17 https://wiki.infinetwireless.com/display/DR/Upgrade+from+R5000+to+Evolution
Operation & Administration – 102
•
•
•
•
•
•
•
•
•
•
General Settings
Enable link Enable/disable wireless link (enabled by default)
Type Set the node type to Master or Slave
Master: can establish connections with all other types of
nodes. It is able to form a network of any topology with other
master nodes. A master node is usually used in the
configuration of the both sides of thePtPlinks and in the
configuration of theBSfor thePtMPlinks
Slave: can only connect to master type nodes (the connection
cannot be established between two slave nodes). A slave node
is usually used in the configuration of theCPE.
MultiBS
(Slave)
Enabled: when the link parameters deteriorate, the CPE will
disconnect from the current base station and try to find the sector
with the best parameters values
Disabled: the CPE will keep the connection with a current base station
until the signal is completely lost
It is available for Slave node only
Mode This setting determines the operating mode of the device. The operating
mode is determined by the application of this node in the network.
Fixed- the node has a fixed position in the network, it is constantly
on. It is a core node of the network. Recalculation of the MINT
connections cost in this mode will occur every 3 seconds.
Nomadic- the node can change its geographic location, but data
exchange within the network, as a rule, occurs when the node does
not move. The cost of MINT connections will be recalculated every 1.5
seconds.
Mobile- the node often moves. Data exchangetake place during the
movement. Recalculation of the cost of MINT connections will occur
every second.
R5000 Compatibility mode Enable/disable compatibility with InfiLINK 2x2 / InfiMAN 2x2 family device
NOTE
Recommendations how to upgrade the wireless network from
the R5000 series to Evolution and limitations that must be taken
into account when R5000 and Evolution devices operate
together in one network are described at "Upgrade from R5000
to Evolution"
17
.