Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 98
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Channel Width Set the bandwidth of the radio interface in MHz
It must be the same at both ends of the link
For 802.11ac mode the values 20, 40 and 80 MHz are available, for
802.11nHT mode - 20 and 40 MHz, for models E5-BSE-L and E5-BSI-L -
20 and 40 MHz
Frequency Set the radio interface frequency (in MHz)
It must be the same at both ends of the link
If it is set to “Auto”, the Slave node is scanning on all frequencies for the
Master nodes
Frequency Range List Set the frequencies that are allowed to be chosen by
theDFSmechanism (available only when theDFS system is enabled)
It is available to support the legacy products
Note that this option is different from the "Customer Frequency Grid"
tool which allows narrowing down the frequency range available in the
"Frequency" option from the Radio profile
Tx Bitrate Set the maximum operating bitrate of the radio interface (from 13000
to 780000 Kbps)
Acts as a top limit for the bitrate if the Autobitrate mechanism is turned
on
By default, it is turned on (it is strongly recommended to remains “on”)
Adjust the Autobitrate system thresholds when the remoteSNRdoesn’t
have the normal level
Channel Type The channel type can be set as:
Dual: enablesMIMOoperational mode with different Tx and Rx
data streams (recommended)
Single: allows to operate asMIMOwith duplicate Tx
streams,MISOorSISOdepending on the Tx/Rx chain
configuration (description below)
InfiNetMIMO2x2 technology effectively doubles the spectrum
efficiency and allows to achieve a real throughput up to 280 Mbps in 40
MHz band
NetworkSID Set the network system identifier (up to 8-digit HEX figure)
It must be the same at both ends of the link
Node ID Set the device identification number
The parameter is optional
Node ID can be configured by the administrator for a better
representation of a neighbors table (nodes within a wireless network)
Security Key Set the secret key word for encoding of the protocol messages
It must be up to 64 characters long, without spaces
It must be the same at both ends of the link
14 Table - Radio settings parameters in the time division networks