Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 94
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
STARSSI (dBm)
(Master)
Set the target power of received radio signal from Slave node at the
input of Master node
The range is from -90 to -20 dBm in increments of 1
It allows to reduce the radiation influence from the subscriber units to
the neighbor sector due to insufficient suppression of the antenna
pattern back lobe
To achieve maximum TDMA network performance it is important to
obtain the highest possible signal level and modulation (bitrates), so
transmitter power reducing is a necessary measure. If possible, it is
better to try to reduce the impact of clients on neighbor sector (and
vice versa), organizational measures (shielding, antennas diversity,
etc.)
DFS
(Master)
Enable/disable DFS
If “DFS only” is set, the DFS system monitors interferences but does not
perform radar detection
If "DFS with Radar Detection" is set, the DFS system monitors
interferences and performs radar detection
For the two radios base stations, the “Instant DFS” option is available
(one of the two radios is used for DFS scanning, Radar detection and
Spectrum analyzing)
Tx Power Set the output power of the radio interface
Acts as a top limit for the output power control if theATPCmechanism
is turned on
Two operating ranges of Tx power are available:
“-10...10” (if chosen top limit is 10 dBm or less)
“0...27” (if chosen top limit is from 10.5 dBm to 27 dBm)
By default, it is turned on (it is strongly recommended to remains “on”)
The offset parameter is used to adjust the thresholds
Node Name Set the name for this node in the network
By default, it is the "Unknown"node
This node name will appear on the neighbor lists
Scrambling Enable/disable the data scrambling to improve the connection stability
(enabled by default)
Trap gateway Enable/disable gateway forSNMP-traps
CAUTION
Please note that, in some countries, switching “DFS off” and/or
failing to detect public service radar signals are against the
regulations and may result in legal action.