Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 92
•
•
•
•
•
•
•
•
•
•
•
•
•
station).When trying to establish a wireless connection, the subscriber terminal selects a base station with
parameters that provide the best connection quality (RSSI, signal-to-noise ratio, bitrate, errors number, retries,
etc.)If connection with the base station is lost, the subscriber terminal will not try to reconnect to it, but will
evaluate the signal parameters of all available base stations sectors.
The "Frequency roaming" function is enabled by default (the "auto" option of the Frequency parameter), and
allows the subscriber terminal with automatic frequency selection (if it has appropriate radio profiles):
Automatically switch from the main base station (roamingleader) to the backup.
Automatically switch between different base stations while moving.
Automatically switch to a new base station frequency if the current base station frequency has changed.
During frequency roaming process the traffic transmission does not stop.The radio link parameters are described in
the table:
Parameter Description
General Settings
Enable link Enable/disable wireless link (enabled by default)
Type Set the node type to Master or Slave
Master: can establish connections with all other types of nodes.
It is able to form a network of any topology with other master
nodes. A master node is usually used in the configuration of the
both sides of thePtPlinks and in the configuration of theBSfor
thePtMPlinks
Slave: can only connect to master type nodes (the connection
cannot be established between two slave nodes). A slave node
is usually used in the configuration of theCPE.
MultiBS
(Slave)
Enabled: when the link parameters deteriorate, the CPE will disconnect
from the current base station and try to find the sector with the best
parameters values
Disabled: the CPE will keep the connection with a current base station
until the signal is completely lost
It is available for Slave node only
VBR
(Slave)
The mode at which the service information is carried out at above a
minimum bitrate (if possible)
Radar Detection
(Slave)
Enable/disable "Radar Detection"features (a special license with the
country code is necessary)
TheDFSsystem performs radar detection and if a radar signal is
detected, that frequency is marked as occupied and it can be used
again only after a hold-down interval (the link is switched
automatically to another frequency)