Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 91
•
•
•
•
•
7.3.3 Link Settings
In the "Link Settings" section you can configure the parameters for the Radio interface, for the Pseudo Radio
interface and for the Join function:
The "Link Setting" section is consist from the following subsections:
"rf6.0" subsection
This subsection is used for:
Radio link settings(see page 91).
Frequency limitation(see page 99).
Setting channel type mode(see page 99).
Radio link settings
"rf6.0" subsection is divided in two zones:
The panel that describes global link settings, in the left side of the page
The panel that describes the radio channel settings which are currently in use, in the right side of the page.
56 Figure - Master node configuration
57 Figure - Slave node configuration
In a point-to-multipoint topology, several profiles can be configured on the Slave device (with parameters for
connecting to each base station sector).A subscriber terminal can connect to more than one base station, both in
nomadic or mobile mode and in a fixed mode for redundancy purposes (a separate profile for each base