Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 90
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Interface type Operations
lagX Link aggregation interface is a logical interface used to combine multiple physical
channels into one logical channel in order to increase link capacity and redundancy
(for the units with two physical Ethernet ports)
Configure the IP address(es) and the mask of the interface
Enable/disable the interface
Enable/disable DHCP - obtain an IP address automatically
Set the interface description (up to 72 characters)
Remove the interface
Set the parent interface to be aggregated the encapsulated packets
Enable/disable Fast Mode
tunX Configure the IP address(es) and the mask of the interface
Enable/disable the interface
Enable/disable DHCP - obtain an IP address automatically
Set the interface description (up to 72 characters)
Remove the interface
Set the tunneling mode: IPIP or GRE
tapX Configure the IP address(es) and the mask of the interface
Enable/disable the interface
Enable/disable DHCP - obtain an IP address automatically
Set the interface description (up to 72 characters)
Remove the interface
13 Table - Network Settings
In the "Network Settings" section, "Routing Parameters" zone, you can configure the static routes:
In the “Network” field, you can configure the destination networkIP-address
In the “Gateway” field, you can configure theIP-address of the router through which the network address is
reachable.
As all wirelessMINTinterfaces are in one virtual Ethernet segment, they can be enumerated by
assigningIPaddresses from oneIPsubnet (manually or automatically, viaDHCP). Thus, getting to one node (via
telnet, for example), you can access all the other nodes. The access from the “outside” network can be established
by configuring the necessary routing, so that the “inner”MINTnetwork can be accessible from the administrator’s
computer through the Ethernet port of theMINTnode which is connected to the “outside” network. From the
“inner”MINTnetwork, the route to the administrator’s computer should go through the radio-interface to the
border router.