Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 87
•
•
•
General System Parameter Description
Use GNSS Position Enable/disable GNSS position
Disabled by default
12 Table - System Settings
Click the «Open Map» button to open the Google map:
55 Figure - Google Map
Type the location name in the "Address bar", click the «Find» button to search for it and then move to the exact
location where the unit is installed. Double click in that position on the map and the Google pointer (see picture
above) will be placed there. After clicking the «OK» button, “Latitude” and “Longitude” fields are automatically filled
in with the GPS coordinates.
7.3.2 Network Settings
In the "Network Settings" section, there are displayed all physical and logical network interfaces that are already
configured. The physical interfaces (eth0 and rf6.0) are set by default and they cannot be removed. For these two
interfaces, you are allowed to change the parameters only.
For the following layer 2 and 3 logical interfaces, you are allowed to add (by clicking the corresponding buttons and
specifying the interface number), remove and change the parameters of the interface:
"PRF" - Pseudo Radio Interface can be attached to the Ethernet interface in order to allow it to work as a
radio interface using theMINTprotocol, so that the node can find its neighbors and establish the links with
them through this interface. The interface encapsulatesMINT-frames into the Ethernet-frames and allows
NOTE
Before making the configurations in the "Network Settings" section, please read the information
presented in the "MAC Switch (see page 103)" section.
