Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 85
•
•
•
•
After performing the needed configuration in the "Basic Settings" menu, you must save all the new parameters by
clicking the «Apply» button. If you are not sure about the effect of the new configuration performed, you can apply
the new configuration temporarily by clicking the «Test» button. The previous configuration is automatically
restored after a grace period of 180 seconds (3 minutes). You have the options to extend the grace period, or
immediately accept/reject the changes.
53 Figure - Settings restore
By clicking the «Preview Configuration» button, you can view the configuration results inCLI-style format.
After clicking the «Apply» button for saving the new configuration, the system will redirect you to the login page.
After a 5 seconds timer you can log in back to the unit and check the new configuration.
The "Basic Settings" page has the following sections:
7.3.1 System Settings
In this section, you can view and edit the basic system settings that are already created.
54 Figure - System Settings default configuration
General System Parameter Description
Device Name You can set the device name
This parameter is displayed in the web-page header
User Name Displays the username (Login) used to access the unit
management interfaces
You can change the current username
NOTE
This message is not displayed in the default configuration, but only after the first configuration via CLI.
