Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
11 https://wiki.infinetwireless.com/display/DR/WANFleX+-+Technical+User+Manual
12 https://wiki.infinetwireless.com/display/DR/WANFleX+-+Technical+User+Manual
Operation & Administration – 82
Remote Commands
The "Remote Commands" tool allows one MINT node to perform commands on another or all MINT nodes in the
network at L2 level usingWANFleX OSCLI commands.
Run the string you typed into the “Command” field by clicking the «Execute» button. For the full list and description
ofWANFleX OSCLI commands, please refer to theWANFleX OS User Manual
11
.
You can set the key grant access to the remote node using the “Key” textbox and clicking the «Execute» button.
Please note that this key must be prior set at the remote node via CLI (commands "guestKey", "fullKey"- see details
in theWanFlex OS User Manual
12
).
Erase the string you typed into the “Command” field and all output from the display section by clicking the «Clear»
button.
Stop a command execution during the execution phase by clicking the «Stop Execution» button.
By clicking the «Close» button, you return to the "Device Status" page.
You can choose between plain and rich text format by marking/unmarking the corresponding
checkbox.
You can execute the same command from the BS to all CPEs in the network (to the nodes that are linked to the BS)
by marking “Send to all” checkbox before clicking the «Execute» button.
You can upload the configuration file to the remote node by clicking the «Upload Config…» button and you can
reboot the remote node by clicking the «Reboot Remote Unit» button (a warning message pops up before the
reboot).
For the ease of usage of the "Remote Commands" tool, the corresponding buttons for the most usedWANFleX
OSCLI commands are available in the right side of the screen:
46 Figure - Remote commands
By clicking the «System Info» button, you fill in the commandfield with "system version,system uptimeandsystem
cpu"commands.
By clicking the «System Config» button, you fill in thecommandfield with "system uptimeandconfig
show"commands.
By clicking the «System Log» button, you fill in the commandfield with "system log show"command.
By clicking the «Routing Table» button, you fill in the commandfield with "netstat -r"command.
By clicking the «ARP Table» button, you fill in the commandfield with "arp view"command.
By clicking the «Switch Statistics» button, you fill in the commandfield with "switch statistics"command.
By clicking the «Link Status» button, you fill in the commandfield with "mint map detail"command.