Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Operation & Administration – 77
•
•
•
•
36 Figure - Extended Link Diagnostics
Five options are available: "Performance Tests", "Antenna Alignment Tool", "Statistics Graphs", "Remote
Commands" and "Link Restart".
Performance tests
The "Performance tests" tool performs link throughput tests for the configured channel bandwidth and on the
current frequency, without radio link interruption.
The "Performance tests" tool generates traffic between the devices and displays the channel throughput for the
traffic with chosen priority. For the full throughput tests of the channel, you must set the highest priority “0” for the
test traffic. In this case, the transmission of any other traffic is stopped for the testing time and the traffic generated
by the tool will occupy all the channel.
The "Performance tests" tool displays the values of the full channel throughput which is available under the current
settings, for current bitrate.
Performance tests contains of8 tests performed on established bitrate, test can be performed in one direction or
bidirectionally.
37 Figure - Performance test
By clicking the «Run Tests»/«Stop Tests» buttons at the bottom of the page, you can start/stop the performance
tests.
By clicking the «Exit Test» button, you return to the "Device Status" page.
Each row corresponds to a certain bitrate value and can be selected or deselected for participating in the
performance test by marking/unmarking the corresponding check-box on the right side. By marking “Select all”
check-box, all the bitrates could be selected or deselected at once.
Three more parameters are available for management:
“Test time” parameter - allows setting the duration (in seconds) of the test for each bitrate (5s by default).
“Bidirectional” check-box - allows choosing between bi-directional (when checked) and unidirectional (when
unchecked) performance test.
"Priority (0-16)"- by default, it is 16, which is lower than the data traffic that has priority 15. You can increase
the test priority by setting a lower value.
"Packet size" -allows to set the desired packet size in bytes.
NOTE
All results are given in kilobits per second and retries levels are shown as a red chart.