Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Installation – 42
•
•
•
•
•
•
•
•
6 Installation
Mounting kit (see page 42)
Cable Gland Assembly (see page 46)
Mounting (see page 47)
Grounding and Lightning Protection (see page 50)
Antenna Alignment (see page 58)
6.1 Mounting kit
MONT-KIT-85 Mounting kit (see page 42)
MONT-KIT-85P Mounting kit (see page 43)
Mounting kit for E5-ST18/E6-ST18(see page 45)
6.1.1 MONT-KIT-85 Mounting kit
MONT-KIT-85 | MONT-KIT-85S is supplied with all models by default except E5-ST18 and E6-ST18.It allows to make
reliable and easy installation of the unit with two-axis adjustment.Assemble the Mounting kit according to the
scheme below. The nut must be tightened until the spring washer clicks, without over-tightening.
Mounting is carried out on a pole with a diameter 30-85 mm. There are also possible options for mounting on a wall
or pole with a diameter more than 85 mm.