Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Planning considerations – 32
•
•
•
•
4.2 Synchronization settings
To perform synchronization using an external hub, each base station sector must be connected to an AUX-ODU-
SYNC.
The following conditions should be met:
Frame size and DL/UL ratio should be equal on all sync-end units.
The automatic downlink ratio selection is not allowed.
4.2.1 Configuration via web interface
To enable synchronization via web interface:
Go to the section "Basic Sttings" →"Link Settings" → "rf6.0".
Check the box "Use AUX-ODU-SYNC" and click "Apply". Synchronization status and the number of visible
satellites is displayed in the "Device Status" -> "Link Statistics" section.
NOTE
The AUX-ODU-SYNC antenna is not included in the standard packing list. For more information about this
antenna, proceed to the AUX-ODU-SYNC(see page 24) article.